Qmark LFK Series - Wall Heater Manuale Utente Scaricare il pdf

“K” Series

Fan Forced

Wall Heaters

(Model A)

Read Carefully - These instructions are written to help you

prevent difficulties that might arise during installation of

heaters. Studying the instructions first may save you consid-

erable time and money later. Observe the following proce-

dures and cut your installation time to a minimum.

1. To prevent electrical shock, disconnect all power coming

to heater at main service panel before wiring or servicing.

2. All wiring must be in accordance with the National and

Local Electrical Codes and the heater must be grounded

as a precaution against possible electric shock.

3. Verify the power supply voltage coming to heater match-

es the ratings printed on the heater nameplate before

energizing.

4. This heater is hot when in use. To avoid burns, do not let

bare skin touch hot surfaces.

5. Do not insert or allow foreign objects to enter any ventila-

tion or exhaust opening as this may cause an electric

shock, fire, or damage to the heater.

6. To prevent a possible fire, do not block air intakes or

exhaust in any manner. Keep combustible materials, such

as crates, drapes, etc., away from heater. Do not install

behind doors, furniture, towels, or boxes.

7. A heater has hot and arcing (sparking) parts inside. Do

not use it in areas where gasoline, paint, or flammable

liquids are stored.

8. Use this heater only as described in this manual. Any

other use not recommended by the manufacturer may

cause fire, electric shock, or injury to persons.

9. This heater is not approved for use in corrosive atmos-

pheres such as marine, green house, or chemical storage

areas.

WARNING

SAVE THESE INSTRUCTIONS

WATTS

4000

4800

VOLTS

208

240

208

240

208

Dear Owner,

Congratulations! Thank you for purchasing this new heater manufactured by Marley Engineered Products.

You have made a wise investment selecting the highest quality product in the heating industry. Please carefully

read the installation and maintenance directions shown in this manual. You should enjoy years of efficient

heating comfort with this product from Marley Engineered Products... the industry’s leader in design,

manufacturing, quality and service.

... The Employees of

Marley Engineered Products

Installation & Maintenance Instructions

FILE #E21609

(400mm)

15-3/4"

(485mm)

19-1/8"

(35mm)

1-3/8"

(95mm)

3-3/4"

(463mm)

18-1/4"

1 2 3 4

Sommario

Pagina 1 - (Model A)

“K” SeriesFan ForcedWall Heaters(Model A)Read Carefully - These instructions are written to help youprevent difficulties that might arise during insta

Pagina 2 - IMPORTANT

Installation of Recessed Back Box in NewConstruction1. Mounting Back Box (See Figure 1).a. Place the back box between two 16" (406mm) center-to-c

Pagina 3 - Operation

3. Power Supply WiringNOTE: Wiring Compartment Volume - 119in3(1950cm3).a. Run correctly sized power supply cable into the areaof the upper right corn

Pagina 4 - K4083A DATE CODE: 0595

IMPORTANT INFORMATIONMaintenanceTO RESET MANUAL RESET LIMITYour heater is equipped with a manual reset safety thermallimit control that will automatic