READ AND SAVE
THESE INSTRUCTIONS
Model MM698, MM698F,
MM698-WC, MM728NL
Heater/Fan/Lights
DESCRIPTION
The MM698, MM698F, MM698-WC, MM728NL Heater/Fan/Light models listed in these instructions are intended for use in bath-
rooms. However, they can also be used in other areas where heat and ventilation is required. All models are U.L. listed type I.C.
(Inherently Protected) for use in insulated ceilings. IMPORTANT: Do not install above bathtub or shower stall enclosure.
UNPACKING
Unpack carefully. If there are missing components or hidden damage, immediately contact your distributor or the delivering
company.
TO REDUCE THE RISK OF FIRE, ELECTRICAL
SHOCK .OR INJURY TO PERSONS, OBSERVE THE
FOLLOWING:
1. Do not use this fan with any Solid-State speed control
device.
2. Use this unit only in the manner intended by the
manufacturer.
3. Before servicing or cleaning unit, switch power off at
service panel and lock service panel to prevent power
from being switched on accidentally.
4. Installation work and electrical wiring must be done by
qualified person(s) in accordance with all applicable
codes and standards, including fire-rated construction.
5. Sufficient air is needed for proper combustion and
exhausting of gases through the flue (chimney) of fuel
burning equipment to prevent backdrafting. Follow the
heating equipment manufacturer’s guideline and safety
standards such as those published by the National Fire
Protection Association (NFPA), and the American Society
for Heating, Refrigeration and Air Conditioning Engineers
(ASHRAE), and the local code authorities.
6. When cutting or drilling into wall or ceiling, do not damage
electrical wiring or other hidden utilities.
7. Ducted fans must always be vented to the outdoors.
8. If this unit is installed over tub or shower, it must be
marked as appropriate for the application. These units are
NOT to be installed over a tub or in a shower stall
enclosure.
9. NEVER place a switch where it can be reached from a
tub or shower.
10. CAUTION: For General Ventilating Use Only! Do not
use to exhaust hazardous or explosive materials or
vapors.
11. Not for use in kitchens.
12. Unit must be installed on a separate 20 amp branch
circuit.
WARNING
TOOLS
Installation of your Marley Engineered Products product is easy. No special technical knowledge is needed; only a few ordinary
tools are required:
• Screwdriver
• Hammer
• Saber saw, Keyhole saw or jig saw
• Electric drill with bit
• Wire cutters
• Wire stripper
• Wire nuts and general electrical supplies
• Safety glasses
• Ruler and straight edge
All hand tools should be insulated. Power tools should display U.L. Listing Mark.
Commenti su questo manuale