Qmark B660W Infrared Heaters Manuale Utente

Navigare online o scaricare Manuale Utente per Ventole Qmark B660W Infrared Heaters. Qmark B660W Infrared Heaters User Manual Manuale Utente

  • Scaricare
  • Aggiungi ai miei manuali
  • Stampa
  • Pagina
    / 4
  • Indice
  • SEGNALIBRI
  • Valutato. / 5. Basato su recensioni clienti
Vedere la pagina 0
Dear Owner,
Congratulations! Thank you for purchasing this new heater/fan manufactured by a division of Marley Engineered Products.
You have made a wise investment selecting the highest quality product in the heating industry. Please carefully read the
installation and maintenance instructions shown in this manual. You should enjoy years of efficient heating comfort with this
product from Marley Engineered Products... the industry’s leader in design, manufacturing, quality and service.
... The Employees of Marley Engineered Products
Read Carefully - These instructions are written to help you
prevent difficulties that might arise during installation of
heaters. Studying the instructions first may save you
considerable time and money later. Observe the following
procedures, and cut your installation time to a minimum.
CAUTION - TO REDUCE RISK OF FIRE, ELECTRICAL SHOCK
OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
1. Do not use this fan with any Solid-State speed control
device.
2. Use this unit only in the manner intended by the
manufacturer. If you have any questions, contact the
manufacturer.
3. Before servicing or cleaning unit, switch power off at
service panel and lock service panel to prevent power
from being switched on accidentally.
4. Installation work and electrical wiring must be done by
qualified person(s) in accordance with all applicable
codes and standards, including fire-rated construction.
5. Sufficient air is needed for proper combustion and
exhausting of gases through the flue (chimney) of fuel
burning equipment to prevent back drafting. Follow the
heating equipment manufacturer’s guideline and safety
standards such as those published by the National Fire
Protection Association (NFPA), and the American
Society for Heating Refrigeration and Air Conditioning
Engineers (ASHRAE), and the local code authorities.
6. When cutting or drilling into wall or ceiling, do not
damage electrical wiring or other hidden utilities.
7. Ducted fans must always be vented to the outdoors.
8. If this unit is installed over a tub or shower, it must be
marked as appropriate for the application. These units
are
NOT to be installed over a tub or in a shower stall
enclosure.
9. Do not install closer than 6” to any adjacent wall.
10. Do not install less than 6’ from floor.
11. Install R-40 reflector type infrared heat lamp/lamps
375-watt maximum (not included).
12. NEVER place a switch where it can be reached from a
tub or shower.
13.
CAUTION: For General Ventilating Use Only!
Do not use to exhaust hazardous or explosive materials
and vapors.
14. Not for use in kitchens.
Installation & Maintenance Instructions
SAVE THESE INSTRUCTIONS
WARNING
!
Models A564&B674
Radiant Infrared Ceiling Heater
Models B560 & B660W
Radiant Infrared Heater/Fan
Combination
DESCRIPTION
The RADIANT INFRARED CEILING HEATERS AND HEATER/FAN COMBINATIONS listed in these instructions are intended
for use in restrooms, bathrooms and utility rooms. Any other applications are not approved. All models are U.L. Listed TYPE
I.C. (Thermally Protected) for use in insulated ceilings.
IMPORTANT: DO NOT INSTALL OVER A TUB OR SHOWER STALL ENCLOSURE.
UNPACKING
Unpack carefully. If there are missing components or hidden damage, immediately contact your distributor or the delivering
carrier concerning discrepancies.
TOOLS
Installation of your Marley Engineered Products heater is easy. No special technical knowledge is needed; only a few ordinary tools are
required.
Screwdriver Wire stripper
Hammer Wire nuts and general electrical supplies
Saber saw, Keyhole saw, or Jig saw Safety glasses
Electric drill with bit Ruler and straight edge
Wire cutters
All hand tools should be insulated. Power tools should display the UL Listing Mark.
Vedere la pagina 0
1 2 3 4

Sommario

Pagina 1 - Combination

Dear Owner,Congratulations! Thank you for purchasing this new heater/fan manufactured by a division of Marley Engineered Products.You have made a wis

Pagina 2 - MODEL B660W

MODEL A564MODEL B560MODEL B674WMODEL B660WMOUNTING BRACKETSOUTLET BOX COVERGRILLE MOUNTINGSPRINGSGRILLECOOLING FANOUTLET BOXGRILLE MOUNTINGSPRINGSGRIL

Pagina 3

2. Remove outlet cover. Run 120VAC, 60Hz power cables from wall switch/switches to appropriate knockout in housing. Removeknockout and install BX or R

Pagina 4 - LIMITED WARRANTY

THERMAL PROTECTIONThis unit is Thermally Protected. If the cooling fan stalls or the unit is not field wired in accordance with th

Commenti su questo manuale

Nessun commento