Qmark 8100FLH Series Environmental Bath Fan Manuale Utente

Navigare online o scaricare Manuale Utente per Ventole Qmark 8100FLH Series Environmental Bath Fan. Qmark 8100FLH Series Environmental Bath Fan User Manual Manuale Utente

  • Scaricare
  • Aggiungi ai miei manuali
  • Stampa
  • Pagina
    / 4
  • Indice
  • SEGNALIBRI
  • Valutato. / 5. Basato su recensioni clienti
Vedere la pagina 0
1
READ AND SAVE THESE INSTRUCTIONS
MODELS 7100A, 7150A, 8090A, & 8100A FANS
MODELS 7100LA, 7150LA, 8090LA, 8100LA, FAN/LIGHTS
DESCRIPTION
The FAN and FAN/LIGHT models listed in these instruc-
tions are intended for use in bathrooms. However, they
can also be used in other areas where ventilation is
required. These units are approved for installation in the
ceiling above a bathtub or shower stall only when con-
nected to a U.L. Listed GFCI protected branch circuit.
ALL FAN/LIGHT models are U.L. Listed Type I.C.
(Inherently Protected) for installation in insulated ceilings.
UNPACKING
Unpack carefully. If there are missing components or hid-
den damage, immediately contact your distributor or the
delivering carrier concerning discrepancies.
IMPORTANT SAFETY INSTRUCTIONS
WARNING:
TO REDUCE RISK OF FIRE, ELECTRICAL SHOCK OR
INJURY TO PERSONS, OBSERVE THE FOLLOWING:
1. Do not use this fan with any Solid-State speed control
device.
2. Use this unit only in the manner intended by the manufa-
cturer. If you have any questions, contact the
manufacturer.
3. Before servicing or cleaning unit, switch power off at
service panel and lock service panel to prevent power
from being switched on accidentally.
4. Installation work and electrical wiring must be done by
qualified person(s) in accordance with all applicable
codes and standards, including fire-rated construction.
5. Sufficient air is needed for proper combustion and
exhausting of gases through the flue (chimney) of fuel
burning equipment to prevent back drafting. Follow the
heating equipment manufacturer’s guideline and safety
standards such as those published by the
National Fire Protection Association (NFPA), and the
American Society for Heating and Air Conditioning
Engineers (ASHRAE), and the local code authorities.
6. When cutting or drilling into wall or ceiling, do not damage
electrical wiring or other hidden utilities.
7. Ducted fans must always be vented to the outdoors.
8. If this unit is installed over a tub or shower, it must be
marked as appropriate for the application. See product
label.
9. NEVER place a switch where it can be reached from a tub
or shower.
10. CAUTION: For General Ventilation Use Only! Do not
use to exhaust hazardous or explosive materials or vapors.
11. Not for use in kitchens.
TOOLS
Installation of your Marley Engineered Products fan is easy. No
special technical knowledge is needed; only a few ordinary
tools are required:
Screwdriver
Hammer
Saber saw, Keyhole saw, or Jig saw
Electric drill with bit
Wire cutters
Wire stripper
Wire nuts and general electrical supplies
Safety glasses
Ruler and straight edge
All hand tools should be insulated. Power tools should display
the UL Listing Mark.
FIG. 1
ROOF CAP
4” ROUND
DUCT
ROOF
FIG. 2
WALL
CAP
4” ROUND
DUCT
Vedere la pagina 0
1 2 3 4

Sommario

Pagina 1

1READ AND SAVE THESE INSTRUCTIONSMODELS 7100A, 7150A, 8090A, & 8100A FANSMODELS 7100LA, 7150LA, 8090LA, 8100LA, FAN/LIGHTSDESCRIPTIONThe FAN an

Pagina 2 - CAUTION!

2NEW HOME INSTALLATION(MODELS: 7100A, 7130A, 7150A, 8090A, 8100A, 7100LA, 7150LA, 8090LA & 8100LA)1. Remove grille assembly from carton and set as

Pagina 3 - 7100LA & 7150LA

3AIR DISCHARGEOUTLETOUTLETBOX COVERGRILLEMOUNTINGTABSBLOWER UNITGRILLE12 1/2”11 13/16”7 5/8”10”11 1/2”GRILLESPRINGBLOWERMOUNTINGSCREWSWIRECONNECTORSMO

Pagina 4 - SPECIFICATIONS:

4SPECIFICATIONS:MODEL VOLTS DUCT CFM H.V.I. Certification (Sq. Ft.)SIZE RATING BATH KITCHEN OTHER8090A/8090LA 120 4” 90 85 N/A 1157100A/7100LA 120 4”

Commenti su questo manuale

Nessun commento